Hi, Jason,

on Dienstag, 28. September 2004 at 22:18 you wrote to amanda-users:

JM> Ok I got it, I was making it way too hard again. Re-read the manual's triple
JM> checked the configs, folders, permissions and rebooted the server and
JM> everything is working now. Figured out there was two things incorrect in my
JM> setup and they were. FreeBSD has to have operator:operator not amanda:disk
JM> for permissions over the amanda client to allow it to properly read so I
JM> redid the port with the default permissions and just set the server and it
JM> worked right off the bat after doing the second part. Found a write up
JM> showing me there are some directories and files that are not created using
JM> the port as well that I had to make and set permissions on. So for those
JM> that have a problem with it here is the link for FreeBSD 4.9 port install
JM> write up and how to fix it.

JM> Http://lists.freebsd.org/pipermail/freebsd-ports-bugs/2003-November/018025.h
JM> tml

This link is dead right now ...

Would be great if you could write a short note about what you had to
do to fix your problem with AMANDA on FreeBSD, so I can add it to the
system.notes in the AMANDA-docs.

Just send it to me offline ...

Thanks.

-- 

best regards,
Stefan

Stefan G. Weichinger
mailto:monitor AT oops.co DOT at