Gil Naveh wrote:
Gene - thanks for trying to help,
Currently the only reason that I can think of is that Amanda has not read
correctly our tape drive so I am re-running
#amtapetype -f /dev/rmt/0n
Add an estimate value! And it takes about 5 hours only. Without
an estimate it takes a week or so. Like this:
amtapetype -f /dev/rmt/0n -e 200g
On the other hand, writing a few bytes is enough to see it the drive
works.
About the problem: you did specify that device in your amanda.conf ?
(I believe that was what Gene was hinting about.)
--
Paul Bijnens, Xplanation Tel +32 16 397.511
Technologielaan 21 bus 2, B-3001 Leuven, BELGIUM Fax +32 16 397.512
http://www.xplanation.com/ email: Paul.Bijnens AT xplanation DOT com
***********************************************************************
* I think I've got the hang of it now: exit, ^D, ^C, ^\, ^Z, ^Q, F6, *
* quit, ZZ, :q, :q!, M-Z, ^X^C, logoff, logout, close, bye, /bye, *
* stop, end, F3, ~., ^]c, +++ ATH, disconnect, halt, abort, hangup, *
* PF4, F20, ^X^X, :D::D, KJOB, F14-f-e, F8-e, kill -1 $$, shutdown, *
* kill -9 1, Alt-F4, Ctrl-Alt-Del, AltGr-NumLock, Stop-A, ... *
* ... "Are you sure?" ... YES ... Phew ... I'm out *
***********************************************************************
|
