James D. Freels wrote:
OK. Stranger by the minute. I removed the first tape (01) and set it
up to use the second tape(02). I issued a "amcheck fea" and it said my
second tape was OK and that I should be able to backup. I then issued
an amflush and it came back with an error. I then rewind the tape with
"mt rewind", turn around and issue another amcheck fea, and the tape has
an error on it. So, the amflush and/or amdump process is writing
something to the tape that causes it to not be usable after that point.
Try "mt -f /dev/st0 status" before and after the amcheck and after the
flush.
Any difference?
--
Paul Bijnens, Xplanation Tel +32 16 397.511
Technologielaan 21 bus 2, B-3001 Leuven, BELGIUM Fax +32 16 397.512
http://www.xplanation.com/ email: Paul.Bijnens AT xplanation DOT com
***********************************************************************
* I think I've got the hang of it now: exit, ^D, ^C, ^\, ^Z, ^Q, F6, *
* quit, ZZ, :q, :q!, M-Z, ^X^C, logoff, logout, close, bye, /bye, *
* stop, end, F3, ~., ^]c, +++ ATH, disconnect, halt, abort, hangup, *
* PF4, F20, ^X^X, :D::D, KJOB, F14-f-e, F8-e, kill -1 $$, shutdown, *
* kill -9 1, Alt-F4, Ctrl-Alt-Del, AltGr-NumLock, Stop-A, ... *
* ... "Are you sure?" ... YES ... Phew ... I'm out *
***********************************************************************
|
