James D. Freels wrote:
If I changed the blocksize, how would I have done so ? If I have the
incorrect tapetype, will this do it ? How can I correct the blocksizes,
etc. ?
On Fri, 2004-04-30 at 10:56, Paul Bijnens wrote:
James D. Freels wrote:
Whoa ! Now I am going back to relabel my tapes. I have issued the
amlabel command and receive a
rewinding, reading label, not an amanda tape
rewinding, writing label fea01
amlabel: writing label: Input/output error
Do you have the NON-rewinding device in amanda.conf ?
Accidently changed the blocksize of the device?
--
Paul Bijnens, Xplanation Tel +32 16 397.511
Technologielaan 21 bus 2, B-3001 Leuven, BELGIUM Fax +32 16 397.512
http://www.xplanation.com/ email: Paul.Bijnens AT xplanation DOT com
***********************************************************************
* I think I've got the hang of it now: exit, ^D, ^C, ^\, ^Z, ^Q, F6, *
* quit, ZZ, :q, :q!, M-Z, ^X^C, logoff, logout, close, bye, /bye, *
* stop, end, F3, ~., ^]c, +++ ATH, disconnect, halt, abort, hangup, *
* PF4, F20, ^X^X, :D::D, KJOB, F14-f-e, F8-e, kill -1 $$, shutdown, *
* kill -9 1, Alt-F4, Ctrl-Alt-Del, AltGr-NumLock, Stop-A, ... *
* ... "Are you sure?" ... YES ... Phew ... I'm out *
***********************************************************************
|