Hi Dick,
It doesn't work with 2.4.4, it's fixed in the latest snapshot
from http://www.iro.umontreal.ca/~martinea/amanda
Jean-Louis
On Tue, Jun 03, 2003 at 09:24:09AM -0000, rwk AT americom DOT com wrote:
> Hi,
>
> I am trying to test the rait output driver in amanda-2.4.4. I am trying
> to get this to work, which, if I understand the rait driver, should work:
>
> tapedev "rait:{file:/backup,file:/mirror}"
>
> But I get:
>
> $ amlabel Tapeless Tape00
> rewinding, reading label, not an amanda tape
> rewinding, writing label Tape00, checking label
> amlabel: no label found, are you sure rait:{file:/backup,file:/mirror} is
> non-rewinding?
>
> With: tapedev "file:/backup" I get:
>
> $ amlabel Tapeless Tape00
> rewinding, reading label Tape00
> rewinding, writing label Tape00, checking label, done.
>
> With: tapedev "file:/mirror" I get:
>
> $ amlabel Tapeless Tape00
> rewinding, reading label Tape00
> rewinding, writing label Tape00, checking label, done.
>
> So I am confident I have the directories set up properly. I can in fact
> amdump to either one separately, but not using rait.
>
> I have also tried:
>
> tapedev "rait:file:/backup"
> and
> tapedev "rait:file:/mirror"
>
> These work as well. It is only when used together that it fails. i.e.:
>
> tapedev "rait:{file:/backup,file:/mirror}"
>
> It is also worth mentioning that:
>
> tapedev "rait:{file:/backup}"
>
> fails with the same error:
>
> $ amlabel Tapeless Tape00
> rewinding, reading label, not an amanda tape
> rewinding, writing label Tape00, checking label
> amlabel: no label found, are you sure rait:{file:/backup} is non-rewinding?
>
> I must be doing something simple wrong. Can anyone make any
> suggestions?
>
> Thanks,
> Dick
--
Jean-Louis Martineau email: martineau AT IRO.UMontreal DOT CA
Departement IRO, Universite de Montreal
C.P. 6128, Succ. CENTRE-VILLE Tel: (514) 343-6111 ext. 3529
Montreal, Canada, H3C 3J7 Fax: (514) 343-5834
|