Hi,
i have a problem with an amanda-2.4.3 installation and amflush.
Problem
multiple amanda-runs went to disk cause of tape-errors.
only last run out of 3 shall be flushed to tape.
Problem if i tell amflush only to flush run named "C:", for example,
amflush does nothing, terminating without sending an e-mail.
after that i have to run amcleanup, and in the generated e-mail it tells me
there where no files to flush, but the tape in the drive is marked as used.
If i move the other dir's out of the holding-area and do an amflush
all works fine.

AFAIR a similar problem was reported a few month back, but i couldn't find
the messages in the mailinglist archives.
Has someone a solution to this problem?
Thanks
Christoph