Re: [Bacula-users] Maximum Bandwidth Per Job Question
2016-02-04 22:22:37
My original question, is anyone using Max Bandwidth successfully and
what are YOUR optimal settings?
This is in the context of having multiple KVM VMs backing up from a
node. If you are not using Max Bandwidth
then this question is not for you. Thanks!
As for looking into ethtool, subtracting the amount bandwidth
average used from capacity and dividing that by the amount
of backup processes minus a percentage for overhead, I can do that,
and understand that well. This is not really my question.
If anyone cares to share, I thank you in advance.
On 2/4/2016 6:31 PM, Heitor Faria
wrote:
Just in time: reading again your initial message I think
you assume it is a network bottleneck.
If it's the case you may use ethtool to fetch the actual
capacity of your ethernet interfaces (even bad cabling can
make a 1000 Gb interface negotiating 100 Mb) and try to
estabilish a lower value for Maximum Bandwidth. It will all
depend of the network demand of your applications.
|
------------------------------------------------------------------------------
Site24x7 APM Insight: Get Deep Visibility into Application Performance
APM + Mobile APM + RUM: Monitor 3 App instances at just $35/Month
Monitor end-to-end web transactions and take corrective actions now
Troubleshoot faster and improve end-user experience. Signup Now!
http://pubads.g.doubleclick.net/gampad/clk?id=272487151&iu=/4140 _______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users
|
|
|