configuring the Solaris 'sgen' driver to bind to L9 changer device
2006-09-17 22:22:53
Hi,
I've got Amanda happily seeing the tape drive itself in the L9, but not
the robotics controller. The L9 is attached to an Sbus 'isp' SCSI card in
the Sparc 20 and it's configured into amanda.conf using the
'/dev/rmt/0lbn' device node (the kernels picks it up as 'st15' during a
reconfiguration boot), and the issue at the moment is working out what is
the correct 'class' string to get the 'sgen' driver to recognise and bind
to the robotics controller.
I've tried using 'QLGC,isp' and just plain 'isp'. The robotics controller
is SCSI ID # 0 going on what the unit's admin screen tells me. There are
two ISP cards in the machine - one LVD/SE card connecting to a Sun hard
disk array, and the diff scsi one going to the L9.
Any idea on what the correct 'class' string for the sgen.conf file should
be?
Thanks,
Craig.
--
Post by Craig Dewick (tm). Web @ "http://lios.apana.org.au/~cdewick".
Email 2 "cdewick AT lios.apana.org DOT au". SunShack @ "http://www.sunshack.org"
Forums @ "http://www.sunshack.org/phpBB2". Also Galleries, tech archive, etc.
Sun Microsystems webring at "http://n.webring.com/hub?ring=sunmicrosystemsu".
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- configuring the Solaris 'sgen' driver to bind to L9 changer device,
Craig Dewick <=
|
|
|