taper write error even though amcheck -sclt says ok.
2005-03-10 13:11:53
Hi,
I'm running amanda 2.4.4p2 on ubuntu linux (Warty) kernel v2.6.8.1.4 I
have a new configuration called "Norstead"; I've amlabel'ed all the
tapes; I put tape "Norstead01" in the drive; I run amcheck (sudo -u
backup amcheck -sclt Norstead) which reports all is ok;
I invoke amdump (sudo -u backup amdump Norstead) the estimates get
done and dump sets start rolling onto my holding disk. The smallest
dump is alsike_boot at 28MB so it's done first and when taper attempts
to write it says:
FAIL taper alsike alsike_boot 20050310 0 [out of tape].
I'm running a DLT8000 with no tape changer, but have set "runtapes 3"
with "autoflush on" on the assumption that when a tape gets full it
will wait for me to load another and kick it with amflush.
Any ideas what I've done/assumed wrong or what I should do next to
sort this out.
regards :-)
BruceS
/var/log/amanda/Norstead/log:
DISK planner alsike alsike_root
DISK planner alsike alsike_boot
DISK planner alsike alsike_archive_a
DISK planner alsike alsike_archive_b
DISK planner alsike alsike_home
START planner date 20050310
WARNING planner tapecycle (8) <= runspercycle (28)
INFO planner Adding new disk alsike:alsike_root.
INFO planner Adding new disk alsike:alsike_boot.
INFO planner Adding new disk alsike:alsike_archive_a.
INFO planner Adding new disk alsike:alsike_archive_b.
INFO planner Adding new disk alsike:alsike_home.
START driver date 20050310
START taper datestamp 20050310 label Norstead01 tape 0
FINISH planner date 20050310
STATS driver startup time 93.144
SUCCESS dumper alsike alsike_boot 20050310 0 [sec 2.967 kb 28284 kps 9532.0
orig-kb 31700]
INFO taper tape Norstead01 kb 32 fm 1 writing file: Input/output error
FAIL taper alsike alsike_boot 20050310 0 [out of tape]
ERROR taper no-tape [[cannot overwrite active tape Norstead01]]
WARNING driver going into degraded mode because of tape error.
SUCCESS dumper alsike alsike_archive_a 20050310 0 [sec 1440.600 kb 13208871
kps 9169.0 orig-kb 15927860]
/etc/amanda/Norstead/amanda.conf:
#
# amanda.conf - NorsteadDailySet1
#
# If your configuration is called, say, "DailySet1", then this file
# normally goes in /etc/amanda/DailySet1/amanda.conf.
# for explanation of the parameters refer to amanda(8) and
# /usr/doc/amanda/WHATS.NEW.gz
org "NorsteadDailySet1" # your organization name for reports
mailto "root" # space separated list of operators at your site
dumpuser "backup" # the user to run dumps under
inparallel 4 # maximum dumpers that will run in parallel
netusage 600 # maximum net bandwidth for Amanda, in KB per sec
# a filesystem is due for a full backup once every <dumpcycle> days
dumpcycle 4 weeks # the number of days in the normal dump cycle
tapecycle 8 tapes # the number of tapes in rotation
runtapes 3 # The maximum number of tapes used in a single run. Note that
# this is an upper bound on the number of tapes, and Amanda may
# use less.
bumpsize 20 MB # minimum savings (threshold) to bump level 1
-> 2
bumpdays 1 # minimum days at each level
bumpmult 4 # threshold = bumpsize * (level-1)**bumpmult
#tpchanger "no-changer" # the tape-changer glue script, see TAPE.CHANGERS
tapedev "/dev/nst0" # the (no-rewind!) tape device.
tapetype DLT-IV # what kind of tape it is (see tapetypes below)
labelstr "^Norstead[0-9][0-9]*$" # label constraint regex: all tapes
# must match.
taperalgo largestfit # Do The largest dump image that will fit on the
# current tape next.
diskdir "/var/spool/amanda" # where the holding disk is
disksize 130 GB # how much space can we use on it
reserve 20 # Always set aside at least 20% of disksize for
# incrementals.
autoflush on # amdump run will flush the dump already on holding disk
# to tape.
infofile "/var/lib/amanda/Norstead/curinfo" # database filename
indexdir "/var/lib/amanda/Norstead/index" # where the index files live
logfile "/var/log/amanda/Norstead/log" # log filename
# tapetypes
define tapetype DLT-IV {
comment "Digital Linear Tape IV"
lbl-templ "/etc/amanda/DLT.ps"
length 40000 mbytes
filemark 8 kbytes
speed 6000 kbytes
}
# dumptypes
define dumptype norstead-std-tar {
program "GNUTAR"
comment "partitions dumped with tar"
compress server fast
index
priority medium
}
--
Bruce S. Skinner
Defence R&D Canada - Atlantic
9 Grove St. <mailto:Bruce.Skinner AT drdc-rddc.gc DOT ca>
P.O. Box 1012 <http://www.drdc-rddc.dnd.ca>
Dartmouth NS
CANADA tel: (902) 426-3100 x205
B2Y 3Z7 fax: (902) 426-9654
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- taper write error even though amcheck -sclt says ok.,
Bruce S. Skinner <=
|
|
|