Backups to the file: device ran just fine.  The vtblc warnings (QIC support)
apparently don't affect anything here.


Dana Bourgeois


> -----Original Message-----
> From: owner-amanda-users AT amanda DOT org 
> [mailto:owner-amanda-users AT amanda DOT org] On Behalf Of Dana Bourgeois
> Sent: Monday, November 10, 2003 9:36 PM
> To: 'Dana Bourgeois'; amanda-users AT amanda DOT org
> Subject: RE: Problem configuring amanda before compiling
> 
> 
> Answered my own question once I had time to dig a little. 
> 
> You need to have the readline-devel rpm installed as well as 
> the readline rpm.  
> 
> No one came forward about the QIC tape warning but I will 
> know after I configure the disk 'tapes' and run an amdump if 
> it's a problem.
> 
> 
> Dana Bourgeois
> 
> 
> > -----Original Message-----
> > From: owner-amanda-users AT amanda DOT org
> > [mailto:owner-amanda-users AT amanda DOT org] On Behalf Of Dana Bourgeois
> > Sent: Monday, November 10, 2003 6:44 PM
> > To: amanda-users AT amanda DOT org
> > Subject: Problem configuring amanda before compiling
> > 
> > 
> > On RedHat, I didn't run into this.  Now I'm on SsSE8.1 and
> > the ./configure gives me a warning that I don't have a 
> > terminal library for interactive amrecover nor do I have the 
> > vtblc stuff needed for QIC tape support. Possibly I don't 
> > care.  I'm going to use the file: driver with this 
> > installation and the chg-multi tape changer.  I have the 
> > readline package installed.  
> > 
> > Anyone know if I care about these warnings and if so, which
> > packages I need to tickle YaST to install for me?  Please 
> > believe that I have already tried searching by package name 
> > and installed several packages that looked pertinent but 
> > didn't make these warnings go away, (ummm... I just reran 
> > ./configure - I didn't see anything that would 
> > remove/invalidate/unconfigure the previous ./configure step).
> > 
> > Clues gratefully accepted.
> > 
> > 
> > Dana Bourgeois
> > 
> > 
> > 
> 
>