Re: [Bacula-users] Using HP Storageworks 1/8 G2 with Bacula
2010-06-13 04:30:22
Am Fri, 11 Jun 2010 22:36:47 -0300 schrieb Daniel Bareiro:
> Hi all!
>
> I'm doing tests with a brand new HP Storageworks 1/8 G2 I plan to use
> with Bacula on Debian GNU/Linux Lenny.
>
> The tape autoloader is connected to a PC through an HP Smart Array P212
> card. It is HP's entry level PCI Express Serial Attached SCSI RAID
> controller.
>
> In these initial tests I intend to make the autoloader and the drive to
> recognize commands sent using mtx and mt, respectively.
>
> However, in the operating system I'm only seeing the tape drive, but not
> the autochanger:
>
>
> backup:~# cat /proc/scsi/scsi
> Attached devices:
> Host: scsi3 Channel: 00 Id: 00 Lun: 00
> Vendor: ATA Model: ST3160211AS Rev: 3.AA Type:
> Direct-Access ANSI SCSI revision: 05
>
>
> But I'm not seeing a /dev/st0 or /dev/nst0 device.
did you try backports kernel 2.6.32 ? (www.backports.org)
- Thomas
------------------------------------------------------------------------------
ThinkGeek and WIRED's GeekDad team up for the Ultimate
GeekDad Father's Day Giveaway. ONE MASSIVE PRIZE to the
lucky parental unit. See the prize list and enter to win:
http://p.sf.net/sfu/thinkgeek-promo
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users
|
|
|