2008/6/27 John Drescher <drescherjm AT gmail DOT com>:
>> mount storage=Tape slot=4
>> 3301 Issuing autochanger "loaded? drive 0" command.
>> 3302 Autochanger "loaded? driver 0", result: nothing loaded.
>> 3901 Unable to open device "Driver-1" (/dev/st0): ERR=dev.c:432 Unable
>> to open device "Driver-1" (/dev/st0): ERR=No medium found
>>
>>
>> As you can see, it is not even attempting an autochanger load 4
>>
> First off use /dev/nst0 instead of /dev/st0.
Good catch, thank you.

>
> Also have you run the autochanger tests?
All the autochanger tests work. It loads tapes, unloads tapes etc.

If I use "mtx -f /dev/sg1 load 4"  then type "mount" in bconsole the
mount works.
If I type "umount" in bconsole, the tape gets put back into slot 4, so
the autochanger is working fine with the current bacula config.

The bacula-sd.conf file is configured correctly. Everything else
works, except the auto-mounting. auto-unmounting works, tapes back up
and restore etc.

-------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users