Re: amtape update command missing?
2006-04-13 07:01:09
Charles, Alan,
The update command was added to the 2.4 branch but not to the 2.5
branch. I will send you
a patch when it will be ready.
Jean-Louis
Charles Smith wrote:
Hello,
Was there ever a response to this question? I couldn't find one in the
archives. I'm having the same problem. chg-zd-mtx says to use `amtape
<conf> update` to populate the changer-barcodes file, but amtape has no
such command, at least not in 2.5.0. (FYI I'm using the opensuse10
rpms)
If it was deprecated, how do I tell chg-zd-mtx/amanda which labels are
associated with what barcodes? Do I just have to manually add entries
in the changer-barcodes file? And will it actually use it?
Thank you,
-Charles Smith
On Thu, 30 Mar 2006 10:53:15 -0800, Alan Jedlow wrote:
Hi,
How do I update the "changer-barcodes" file under AMANDA 2.5.0? The
update command is missing from amtape:
amtape: unknown command "update"
Usage: amtape <conf> <command>
Valid commands are:
reset Reset changer to known state
eject Eject current tape from drive
clean Clean the drive
show Show contents of all slots
current Show contents of current slot
slot <slot #> load tape from slot <slot #>
slot current load tape from current slot
slot prev load tape from previous slot
slot next load tape from next slot
slot advance advance to next slot but do not load
slot first load tape from first slot
slot last load tape from last slot
label <label> find and load labeled tape
taper perform taper's scan alg.
device show current tape device
... it's still mentioned in the man page:
update Update the changer label database, if it has one, to match
the tapes now available.
thanks,
alan
|
|
|