Re: debugging chg-scsi
2004-11-04 16:00:16
On Thu, 4 Nov 2004 14:51:54 -0600, Erik Anderson <erikerik AT gmail DOT com>
wrote:
> Okay - here's the deal. My /dev/sg* entries are symlins. They're
> pointing as follows:
>
> /dev/sg0 -> scsi/host0/bus0/target0/lun0/generic
> /dev/sg1 -> scsi/host1/bus0/target1/lun0/generic
> /dev/sg2 -> scsi/host1/bus0/target3/lun0/generic
>
> The permissions on the symlinks are 555, but the permissions on the
> targets are 660, which is correct.
Sorry - hit the send button prematurely there.
If I put the full path to the device into chg-scsi.conf instead of the
symline, I get this:
amanda@lpdlnx00 LPD $ amcheck LPD
Amanda Tape Server Host Check
-----------------------------
Holding disk /dumps/amanda: 36514756 KB disk space available, that's plenty
amcheck-server: could not get changer info: open:
/dev/scsi/host1/bus0/target1/lun0/generic: Success
Amanda Backup Client Hosts Check
--------------------------------
Client check: 0 hosts checked in 0.001 seconds, 0 problems found
(brought to you by Amanda 2.4.4p2)
With the full path to the scsi devices in chg-scsi.conf, amcheck
executes in about a quarter second, so that doesn't seem right.
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Re: debugging chg-scsi, (continued)
- Re: debugging chg-scsi, Christoph Scheeder
- Re: debugging chg-scsi, Erik Anderson
- Re: debugging chg-scsi,
Erik Anderson <=
- Re: debugging chg-scsi, Christoph Scheeder
- Re: debugging chg-scsi, Frank Smith
- Re: debugging chg-scsi, Erik Anderson
- Re: debugging chg-scsi, Gene Heskett
- Re: debugging chg-scsi, Eric Schnoebelen
- Re: debugging chg-scsi, Gene Heskett
- Re: debugging chg-scsi, Erik Anderson
- Re: debugging chg-scsi, Gene Heskett
- Re: debugging chg-scsi, Stephen Carville
Re: debugging chg-scsi, Jon LaBadie
|
|
|