That is the problem. Both the drive and the robot are on SCSI ID 5. Can you
give me a quick how-to or point me in the right direction?

Thanks,
John

-----Original Message-----
From: Joshua Baker-LePain [mailto:jlb17 AT duke DOT edu] 
Sent: Tuesday, May 20, 2003 11:03 AM
To: Block, John
Cc: 'amanda-users AT amanda DOT org'
Subject: Re: andataco dlt library on Redhat.


On Tue, 20 May 2003 at 10:41am, Block, John wrote

> I am trying to get my andataco dlt library to be seen by my RedHat Linux
> system.  It can see the drive, but not the auto-changer.  Any suggestions?

Are the drive and the changer on the same SCSI ID, but different LUNs?  If 
so, you'll need to recompile the kernel enabling "Scan all LUNs" support.

If not, post the output of 'cat /proc/scsi/scsi'

-- 
Joshua Baker-LePain
Department of Biomedical Engineering
Duke University