Re: [Veritas-bu] Dual path tape drives
2009-03-11 13:15:57
Yes in 6.5. I don't remember if you can do it for 6.0
stefanos
-----Original Message-----
From: veritas-bu-bounces AT mailman.eng.auburn DOT edu
[mailto:veritas-bu-bounces AT mailman.eng.auburn DOT edu] On Behalf Of griff
Sent: Tuesday, March 10, 2009 6:39 PM
To: VERITAS-BU AT mailman.eng.auburn DOT edu
Subject: [Veritas-bu] Dual path tape drives
Is there a way to configure the same tape drive on two fiber channels? I am
using Netbackup 6.0 MP6.
The way I have it set up now is the robot and half of the drives are set up
on one fiber path and the other half of the drives are set up on the other
fiber path. Can the robot and drives be seen by both fiber paths so if one
goes down the other can take over?
Thanks in advance.
+----------------------------------------------------------------------
|This was sent by jfairburn AT earthlink DOT net via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
_______________________________________________
Veritas-bu maillist - Veritas-bu AT mailman.eng.auburn DOT edu
http://mailman.eng.auburn.edu/mailman/listinfo/veritas-bu
|
<Prev in Thread] |
Current Thread |
[Next in Thread> |
Re: [Veritas-bu] Dual path tape drives,
smpt <=
|
|
|