Re: [Networker] staging (or something else?
2008-09-26 02:51:00
On Friday, 26. September 2008 08:50:56 Howie Jock wrote:
> Hi Sid
>
> If you change the 'Enabled' status of the AFT devices in your old
> appliance to 'Service' you can read from them but they will not be
> written to, allowing you to edit your relevant Staging policy and select
> 'stage all save sets' to write them out to volumes in the policy's
> destination pool
Nope,
service mode will only allow the device to complete an ongoing operation and
then disable it. The hing to do is to set the Readonly attribute for the
volume(s) on that device and then stage them
Best
Dag
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|