Mithun,
The application you have on the Web Console only requires the switch to
support the dot1dBridge MIB (RFC 1493).
Cheers,
Jane
Mithun Prakash Prabhu wrote:
Hi list,
I have installed Netview ver 7.1.3, I have discovered some Cisco 4006
switches via the server discovery. Now I wanted to know what MIB you
need to load in order to find out the INACTIVE ports in a cisco
switch. Ie those ports where its either not been used or been disabled.
Also when I open the NV Web console using a login id and password I
see there a view inactive ports in a network device option, which
gives me no values. I have some cisco MIBs downloaded but don’t know
which one’s will help me. Please can any one let me know the same.
Thanks in Advance.
/*/Regards,/*/
/*/Mithun Prabhu /*/*/
/*
------------------------------------------------------------------------
---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe AT lists.tivoli DOT com
For additional commands, e-mail: nv-l-help AT lists.tivoli DOT com
*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)
--
Tivoli Certified Consultant & Instructor
Skills 1st Limited, 2 Cedar Chase, Taplow, Bucks, SL6 0EU, UK
Tel: +44 (0)1628 782565
Copyright (c) 2003 Jane Curry <jane.curry AT skills-1st.co DOT uk>. All rights
reserved.
|
