Re: [Bacula-users] When does bacula use multiple tape drives
2014-03-31 08:44:58
> I am trying to configure a dual drive tape library. My challenge is that
> bacula seems to only use one drive. What determines in bacula when it is
> optimal to use two drives? I am using bacula Version: 5.2.13. Additionally
> I have set "Maximum Concurrent Jobs = 4" in all the relevant places, but all
> this seems to do is allow multiple concurrent jobs run, which I have tested
> and seems to work, but strangely, I was under the impression that one job
> could write to one tape exclusively. But in this case, it seems multiple
> jobs can write to the same tape concurrently or is this not correct? Lastly
> I have specified spool directory, however it is never used. Any ideas here
> would be appreciated or clarity.
Bacula can write to more than 1 drive at a time. However I believe by
default bacula can not load the same pool into more than 1 drive at a
time.
> I have included the relevant sections below for the bacula-sd.conf
Your bacula-sd.conf looks fine to me.
John
------------------------------------------------------------------------------
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users
|
|
|