Dear John,
In message <CAEhu1-6BLDpXhGvzWaU+hqB2QH_TkDfL-ybOVP52CoPGZ6CVGA AT mail.gmail
DOT com> you wrote:
>
> > bacula seems to only use one drive. What determines in bacula when it is
> > optimal to use two drives? I am using bacula Version: 5.2.13. Additionally
> > I have set "Maximum Concurrent Jobs = 4" in all the relevant places, but all
> > this seems to do is allow multiple concurrent jobs run, which I have tested
> > and seems to work, but strangely, I was under the impression that one job
> > could write to one tape exclusively. But in this case, it seems multiple
> > jobs can write to the same tape concurrently or is this not correct? Lastly
> > I have specified spool directory, however it is never used. Any ideas here
> > would be appreciated or clarity.
>
> Bacula can write to more than 1 drive at a time. However I believe by
> default bacula can not load the same pool into more than 1 drive at a
> time.
Yes, it can.
Best regards,
Wolfgang Denk
--
DENX Software Engineering GmbH, MD: Wolfgang Denk & Detlev Zundel
HRB 165235 Munich, Office: Kirchenstr.5, D-82194 Groebenzell, Germany
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd AT denx DOT de
Two wrongs don't make a right, but three rights make a left.
------------------------------------------------------------------------------
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users
|