Re: [BackupPC-users] Prepare for the worst, Howto backup the backuppc-se

1) Is is also possible to add a 3rd harddrive via USB or Firewire to the
RAID1 and then using your idea to detach and reattach the harddrive?

yes, that is a very good method. I suggest you try to do esata but usb or firewire will work. esata is just much faster.

2) When I attach the harddrive to my RAID 1, is md smart enough to just
transfer the changes to the attached drive or will it make a full sync?
(sorry for this newbie question)

it is smart enough to only read identical blocks on the disk and only write changed blocks. you still have to wait, at a minimum, the time it takes to do an entire sequential read of the disk plus the time to write the changes to the disk.

other stuff
iscsi:
you do not have to have any kind of high end fancy iscsi SAN, you can make an iSCSI target with a regular linux machine. iSCSI is not terribly hard to setup, but you would need some sore of dedicated equipment, either a small server or a stand alone device.

AoE: another very very handy solution is ATA-over-Ethernet. It is something like iscsi but is not a protocol on top of IP, it is a protocal on the same level as IP. That means that you cannot route it between networks which could be considered a negative but the BIG positive is that you need ZERO IP configuration.

When you make an AoE server, you export disks with a "shelf" + "slot" topology that is carried over to each machine that sees the AoE.

For example. on your linux server, you do AoE with a program called vblade and you make a disk vblade 0 0 which is shelf 0 slot 0. you can then do another disk that is shelf 0 slot 1. on another server you can do a shelf 1 slot 0 and so on.

on every single machine that can see the AoE disks(because they have the aoe module running) they all see the same drives with the same ID. /dev/etherd/e0.0 for shelf0slot0 /dev/etherd/e0.1 for shelf0slot1.

on your backuppc server, you can add /dev/etherd/e0.1 to the mirror, you could even add two AoE disks or more to the mirror if you desired. You can even export AoE disks(with vblade) that are just disk images.

The beauty of this system is that the backuppc server can be on a server rack and all the hot swapping of drives can be done on a linux machine somewhere else. this happens buy exporting a USB drive on the linux machine via AoE and having backuppc watch for the AoE disk and running the appropriate mdadm script. If you really wanted to get creative, you could run linux in a vmware vm and tie a specific USB port to that vm, now you can export the USB disk over AoE on linux, while running WinXP on your desktop. ubuntu server with AoE can run in a 128MB of ram vm quite well.

AoE works without IP overhead so is very fast. near-wire speeds on 100Mb ethernet or even gigabit.

Maybe I'm crazy, I don't know!

-------------------------------------------------------------------------
Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW!
Studies have shown that voting for your favorite open source project,
along with a healthy diet, reduces your potential for chronic lameness
and boredom. Vote Now at http://www.sourceforge.net/community/cca08

_______________________________________________
BackupPC-users mailing list
BackupPC-users AT lists.sourceforge DOT net
List:    https://lists.sourceforge.net/lists/listinfo/backuppc-users
Wiki:    http://backuppc.wiki.sourceforge.net
Project: http://backuppc.sourceforge.net/

Re: [BackupPC-users] Prepare for the worst, Howto backup the backuppc-server