Re: tsm not recognizing tape unit
2006-10-12 14:17:29
>From what I have seen on this thread, the drives in question are IBM
LTO3 drives. The TSM device driver cannot be used with these. Only the
IBM Atape device drive must be used. You have to de-install the TSM
device driver, install the IBM device driver and this should work.
Guillaume Gilbert
Storage Architect
Storage Group, Sun Microsystems
guillaume.gilbert AT sun DOT com
514.866.8876 Office
514.290.6526 Cell
-----Original Message-----
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of
Mark Stapleton
Sent: October 11, 2006 15:57
To: ADSM-L AT VM.MARIST DOT EDU
Subject: Re: [ADSM-L] tsm not recognizing tape unit
From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] On Behalf Of
Mario Behring No. But, just out of curiosity, is there any difference if
it is started at boot time or not ?
Indeed it does! If it doesn't start at boot time, the OS takes over the
device when it loads its drivers.
--
Mark Stapleton
Senior TSM engineer
Evolving Solutions, Minneapolis
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Re: tsm not recognizing tape unit, (continued)
- Re: tsm not recognizing tape unit, Richard van Denzel
- Re: tsm not recognizing tape unit, Bernaldo de Quiros, Iban 1
- Re: tsm not recognizing tape unit, Mario Behring
- Re: tsm not recognizing tape unit, Jeremy Cloward
- Re: tsm not recognizing tape unit, Mario Behring
- Re: tsm not recognizing tape unit, Jeremy Cloward
- Re: tsm not recognizing tape unit, Mario Behring
- Re: tsm not recognizing tape unit, Jeremy Cloward
- Re: tsm not recognizing tape unit, Leigh Reed
|
|
|