Re: tsm not recognizing tape unit
2006-10-11 15:00:39
Richard,
The device is connected to a SCSI 160 and is being recognized by the SCSI
interface during the boot process. Windows 2000 also recognizes the unit. I am
updating the firmware and returning the driver to the version you have pointed.
The Windows RSM service is disabled............but, what about the TSM Device
Driver component? Should I install it? I´ve tried with and without
it.........some notes at the Admin Guide are saying that I can do either
way.............
Please advise.
Mario
----- Original Message ----
From: Richard van Denzel <r.vandenzel AT BSU DOT NL>
To: ADSM-L AT VM.MARIST DOT EDU
Sent: Wednesday, October 11, 2006 4:17:14 AM
Subject: Re: tsm not recognizing tape unit
Hi Mario,
Guessing from your notes, you have ran the install.exe that comes with the
driver. The driver you are using is not the latest (6.1.3.8 is). Have you tried
using an older driver like 6.0.8.2 (I can e-mail it if you don't have it)?
What FW has the LTO3 drive, if not the latest have you tries upgrading the FW
on the drive?
Is the drive visible on the HBA (Fibre or SCSI) during the BIOS part of the
boot process?
Is the HBA at a supported FW level?
If the HBA is a SCSI-320? If so, have you tried setting it to 160, there is an
issue when the drive or library is on a 320 channel.
Is the drive visible under W2K?
Met vriendelijke groet, with kind regards,
Richard van Denzel
-----Oorspronkelijk bericht-----
Van: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU] Namens Mario
Behring
Verzonden: dinsdag 10 oktober 2006 22:45
Aan: ADSM-L AT VM.MARIST DOT EDU
Onderwerp: [ADSM-L] tsm not recognizing tape unit
Hi list,
I have the following environment:
TSM 5.3.2 Server running on a W2K box
IBM ULTRIUM III LTO 3580 connected via SCSI
I´ve installed the windows certified driver downloaded from the
ftp://ftp.software.ibm.com/storage/devdrvr/Windows/Win2000/Latest/ and
ftp://ftp.software.ibm.com/storage/devdrvr/Windows/Win2000/LTO_WHQL_Cert.................I´ve
tried both versions...........looks like that only the certified one
works.....................the install output is below:
Running installation application, version 6.1.3.5.
Preparing system for driver installation...
Uninstalling existing tape drives...
Existing tape drives successfully uninstalled.
Installing/updating the tape bus enumerator...
Successfully installed/updated the tape bus enumerator.
Installing driver for tape drives...
Driver for tape drives installed.
Program successful.
I´ve also disabled the Windows Removable Storage service.
Unfortunatelly TSM does not recognize the tape unit. I´ve tried this with and
without the TSM Device Driver. Looks like TSM Device Driver does not support
the IBM LTO Ultrium tape units................The output from the tsmdlst
command is as follows:
>tsmdlst
Tivoli Storage Manager -- Device List Utility
Licensed Materials - Property of IBM
5697-TSM (C) Copyright IBM Corporation 2000, 2005. All rights reserved.
U.S. Government Users Restricted Rights - Use, duplication or disclosure
restricted by GSA ADP Schedule Contract with IBM Corporation.
Computer Name: TIVOLI
OS Version: 5.0
OS Build #: 2195
TSM Device Driver: ADSMScsi - Not Running
No HBAs were detected.
Reason: Unable to load HBA vendor library.
TSM Name ID LUN Bus Port SSN WWN TSM Type Device
Identifier
----------------------------------------------------------------------------------------------------------------
mt6.0.0.2 6 0 0 2 - - LTO IBM
ULT3580-T
D3 57F7
Completed in: 0 days, 0 hours, 0 minutes, 1 seconds.
I am not sure about what´s going on..........any help is appreciated.
Thanks
Mario
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- tsm not recognizing tape unit, Mario Behring
- Re: tsm not recognizing tape unit, Richard van Denzel
- Re: tsm not recognizing tape unit, Bernaldo de Quiros, Iban 1
- Re: tsm not recognizing tape unit,
Mario Behring <=
- Re: tsm not recognizing tape unit, Jeremy Cloward
- Re: tsm not recognizing tape unit, Mario Behring
- Re: tsm not recognizing tape unit, Jeremy Cloward
- Re: tsm not recognizing tape unit, Mario Behring
- Re: tsm not recognizing tape unit, Jeremy Cloward
- Re: tsm not recognizing tape unit, Leigh Reed
|
|
|