You can use the mib application builder ,or the provided mib applications.
The builder is under Tools..MIB...Tool Builder. The existing mib
applications are under Monitor...MIB Properties. On unix there are two -
one that runs rnetstat, which may only show numbered interfaces and another
that shows the interface table, numbered or not. It may be the same on
windows. Add or modify the one that shows the interface table to include
the ifIndex if it is not there. Make sure it includes ifAdminStatus and
ifOperStatus. This allows users to display realtime mib values more
conveniently than the mib browser.

Netview should discover and draw non-ip interfaces IF they are connected to
other routers in the map, such as serial connections. This works best for
cisco routers with cdp enabled. Otherwise it uses route table information
to determine the connections.

The gtmd and xxmap applications are intended for software developers to
depict and monitor non-ip entities like SNA network devices or application
status, etc.

Cordially,

Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking
Detroit



                                                                                
                                                 
                      tivoli                                                    
                                                 
                      <[email protected]        To:                              
                                                 
                      ion.ro>                  cc:       nv-l AT lists.tivoli 
DOT com                                                   
                                               Subject:  Re: [nv-l] NetView 
Collect Data                                         
                      09/19/2003 05:00                                          
                                                 
                      AM                                                        
                                                 
                                                                                
                                                 
                                                                                
                                                 




hi there

netview 713 on windows: there is any way to display non -ip interfaces
of a router? in netmon.seed I have almost all routers prefixed with an
$ (because I don't have icmp connectivity to all ip interfaces - there
are lots of tunnels blablabla) and I saw in help something about some
daemons for non-ip devices: gtmd and xxmd.
thanks
Lucian



---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe AT lists.tivoli DOT com
For additional commands, e-mail: nv-l-help AT lists.tivoli DOT com

*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)





---------------------------------------------------------------------
To unsubscribe, e-mail: nv-l-unsubscribe AT lists.tivoli DOT com
For additional commands, e-mail: nv-l-help AT lists.tivoli DOT com

*NOTE*
This is not an Offical Tivoli Support forum. If you need immediate
assistance from Tivoli please call the IBM Tivoli Software Group
help line at 1-800-TIVOLI8(848-6548)