Re: [Networker] Drives available but inquire sees nothing

According to the SAN compatibility guide there is a hot fix available for
6.1.1 which will allow support for my FC HBA (IBM 6228).

It says that only only IBM 3584 and 3583 Tape Libraries are supported with
this card.   I have an Adic Scalar 100 with DLT8000 devices.  I dont plan to
use the robot from this Client, just the drives.




- Original Message -----
From: "Davina Treiber" <treiber AT HOTPOP DOT COM>
To: <NETWORKER AT LISTMAIL.TEMPLE DOT EDU>
Sent: Thursday, May 08, 2003 12:06 PM
Subject: Re: [Networker] Drives available but inquire sees nothing


> On Thu, 8 May 2003 10:30:37 +0100, Mark T Wragge <storage AT TTT DOT IE> 
> wrote:
>
> >Hi,  I have an AIX .4.3.3 system with SAN attached tape devices. My fibre
> card is IBM which is an emulex card and using the emulex driver.
> >
> >When using the lputil utility I can see that my fibre card is available
> and I can see that it can see the WWN of the Bridge, robot and all three
> tape devices.
> >
> >When I run lsdev -C -c tape I can see my tape devices with appropriate
> device names.
> >
> >When I open smit I can see my tape devices with appropriate device names
> (/dev/rmt0 etc.)
> >
> >In /dev/rmt the appropriate device names are listed..
> >
> >But the ./inquire command does not see anything related to the SAN
> configuration.   Why could this be and should it prevent a successful
> installation.   I would usually use the inquire command to confirm that
all
> of my hardware is seen by the OS and I can begin to install networker.
>
> If your SAN configuration is not supported by Legato, there may not be the
> correct entries in the lus.conf file. This will prevent them showing up
> from the inquire command. It will probably not prevent a successful
install.
>
> --
> Note: To sign off this list, send a "signoff networker" command via email
> to listserv AT listmail.temple DOT edu or visit the list's Web site at
> http://listmail.temple.edu/archives/networker.html where you can
> also view and post messages to the list.
> =*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
>

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=