On Thu, 8 May 2003 12:36:21 +0100, Mark T Wragge <storage AT TTT DOT IE> wrote:

>According to the SAN compatibility guide there is a hot fix available for
>6.1.1 which will allow support for my FC HBA (IBM 6228).
>
>It says that only only IBM 3584 and 3583 Tape Libraries are supported with
>this card.   I have an Adic Scalar 100 with DLT8000 devices.  I dont plan
to
>use the robot from this Client, just the drives.

As far as lus.conf entries are concerned, it won't matter whether or not
your drives and library are supported, the important things is that the
lus.conf entry matches your HBA.

If it's a hotfix for 6.1.1, does that mean it is included in 6.1.2 and/or
6.1.3? I always prefer to use a released version rather than a hotfix if
possible.

--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=