[Networker] Drives available but inquire sees nothing
2003-05-08 05:31:27
Hi, I have an AIX .4.3.3 system with SAN attached tape devices. My fibre card
is IBM which is an emulex card and using the emulex driver.
When using the lputil utility I can see that my fibre card is available and I
can see that it can see the WWN of the Bridge, robot and all three tape devices.
When I run lsdev -C -c tape I can see my tape devices with appropriate device
names.
When I open smit I can see my tape devices with appropriate device names
(/dev/rmt0 etc.)
In /dev/rmt the appropriate device names are listed..
But the ./inquire command does not see anything related to the SAN
configuration. Why could this be and should it prevent a successful
installation. I would usually use the inquire command to confirm that all of
my hardware is seen by the OS and I can begin to install networker.
Thanks in advance, Mark
--
Note: To sign off this list, send a "signoff networker" command via email
to listserv AT listmail.temple DOT edu or visit the list's Web site at
http://listmail.temple.edu/archives/networker.html where you can
also view and post messages to the list.
=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=*=
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [Networker] Drives available but inquire sees nothing,
Mark T Wragge <=
|
|
|