[Bacula-users] Job transfer rate
2014-10-30 09:48:38
Hi,
I have some backups going at 2MB/s which for a 380gig backup is just too slow.
I’m trying to find my bottleneck.
Some questions:
- Is the rate of the backup only shown in “messages” or is it stored in the db
anywhere. Or could I just do jobbytes / endtime-starttime in the jobs table?
- Does bacula write data to disk via a stream or lots of little latency
dependant writes?
My environment looks like this
- Bacula (and postgres on the same VM), a MS Small business server and 3 or 4
other VMs run on a 6 disk array of 7200rpm SATA disks ( I bet this is already
my slowpoint )
- Bacula stores its backups on a NFS mounted NAS, about .7ms of ping away.
Tips/Suggestions?
Jeff.
------------------------------------------------------------------------------
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [Bacula-users] Job transfer rate,
Jeff MacDonald <=
|
|
|