On Thu, Mar 01, 2012 at 10:32:18AM +0100, Tilman Schmidt wrote:

> Nothing since the last reboot except the normal "Block limits":
> 
> [ts@backup ~]$ dmesg | tail
> ADDRCONF(NETDEV_UP): eth0: link is not ready
> RPC: Registered udp transport module.
> RPC: Registered tcp transport module.
> RPC: Registered tcp NFSv4.1 backchannel transport module.
> e1000e: eth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: Rx/Tx
> ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
> Installing knfsd (copyright (C) 1996 okir AT monad.swb DOT de).
> NFSD: Using /var/lib/nfs/v4recovery as the NFSv4 state recovery directory
> NFSD: starting 90-second grace period
> st0: Block limits 1 - 16777215 bytes.
> [ts@backup ~]$
> 
> Thanks,
> Tilman

Hmm, I was "hoping" for some scsi timeouts or similar which might
explain why the device is apparently stuck labelling a tape... do you
have physical access to the device? Any status lights indicating an
error condition (obvious detail, but I'd rather make sure ;-) 

Cheers, Uwe 

-- 
NIONEX --- Ein Unternehmen der Bertelsmann AG



------------------------------------------------------------------------------
Virtualization & Cloud Management Using Capacity Planning
Cloud computing makes use of virtualization - but cloud computing 
also focuses on allowing computing to be delivered as a service.
http://www.accelacomm.com/jaw/sfnl/114/51521223/
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users