Am 01.03.2012 09:30, schrieb Uwe Schuerkamp:

>> Device status:
>> Autochanger "HP1x8autoloader" with devices:
>>    "LTO-3" (/dev/nst0)
>> Device "FileStorage" (/tmp) is not open.
>> Device "LTO-3" (/dev/nst0) is not open.
>>     Device is blocked labeling a Volume.
>>     Drive 0 is not loaded.

>> *release LTO-3
>> 3921 Device "LTO-3" (/dev/nst0) already released.
>> *unmount LTO-3
>> 3901 Device "LTO-3" (/dev/nst0) is already unmounted.
>> *mount LTO-3 slot=3
>> 3903 Device "LTO-3" (/dev/nst0) is being labeled.
>> *

> do you see any weird error messages in "dmesg" output? 

Nothing since the last reboot except the normal "Block limits":

[ts@backup ~]$ dmesg | tail
ADDRCONF(NETDEV_UP): eth0: link is not ready
RPC: Registered udp transport module.
RPC: Registered tcp transport module.
RPC: Registered tcp NFSv4.1 backchannel transport module.
e1000e: eth0 NIC Link is Up 1000 Mbps Full Duplex, Flow Control: Rx/Tx
ADDRCONF(NETDEV_CHANGE): eth0: link becomes ready
Installing knfsd (copyright (C) 1996 okir AT monad.swb DOT de).
NFSD: Using /var/lib/nfs/v4recovery as the NFSv4 state recovery directory
NFSD: starting 90-second grace period
st0: Block limits 1 - 16777215 bytes.
[ts@backup ~]$

Thanks,
Tilman

-- 
Tilman Schmidt
Phoenix Software GmbH
Bonn, Germany

------------------------------------------------------------------------------
Virtualization & Cloud Management Using Capacity Planning
Cloud computing makes use of virtualization - but cloud computing 
also focuses on allowing computing to be delivered as a service.
http://www.accelacomm.com/jaw/sfnl/114/51521223/
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users