Re: [Bacula-users] Eject button on drive and mount/unmount
2008-07-14 10:09:51
Still using 1.38.11.
John Drescher wrote:
> On Thu, Jul 10, 2008 at 5:14 AM, Felix Brack <fb AT ltec DOT ch> wrote:
>> Hello,
>>
>> I have a simple setup with bacula and one AIT drive. The backup strategy
>> is quite simple as well: one pool with 4 daily tapes and one pool with 5
>> weekly tapes (for Fridays). The backup is run at 23:30.
>>
>> To make it as simple as possible for the persons responsible of changing
>> the tapes I told them to push the eject button of the drive, remove the
>> 'old' tape and then insert the 'new' tape. Note: these people never use
>> a console to issue mount or unmount commands.
>>
>> My setting for the device in the storage daemon configuration file are
>> as follows:
>>
>> Device {
>> Name = SONY-SDX-470V
>> Archive Device = /dev/nst0
>> Media Type = AIT-1-TURBO
>> Always Open = yes
>> Volume Poll Interval = 2 minutes
>> Removable Media = yes
>> Random Access = no
>> Requires Mount = no
>> Offline On Unmount = yes
>> Automatic Mount = yes
>> }
>>
>> Now bacula gets confused about the status of the tape drive and
>> therefore quite often fails to run backups. If I manually issue the
>> unmount command from the console, then replace the tape and issue a
>> mount command, bacule works as expected.
>>
> What version of bacula are you using?
>
> John
-------------------------------------------------------------------------
Sponsored by: SourceForge.net Community Choice Awards: VOTE NOW!
Studies have shown that voting for your favorite open source project,
along with a healthy diet, reduces your potential for chronic lameness
and boredom. Vote Now at http://www.sourceforge.net/community/cca08
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users
|
<Prev in Thread] |
Current Thread |
[Next in Thread> |
Message not available
- Re: [Bacula-users] Eject button on drive and mount/unmount,
Felix Brack <=
|
|
|