[Bacula-users] btape Autochanger unload error's
2008-06-18 03:15:55
Hello,
I got a problem that Bacula won't unload
and load a new tape during a job. mount and umount commands work sometimes
from bconsole but not automatically in the middle of a job once the tape
is full.
Here is my btape output, all write tests
passed correctly.
=== Autochanger test ===
3301 Issuing autochanger "loaded"
command.
Slot 24 loaded. I am going to unload
it.
3302 Issuing autochanger "unload
24 0" command.
unload status=Bad 268435457
3992 Bad autochanger command: /usr/libexec/bacula/mtx-changer
/dev/changer unloa
d 24 /dev/nst0 0
3992 result="Unloading Data Transfer
Element into Storage Element 24...mtx: Requ
est Sense: Long
Report=yes
": ERR=Child exited with code 1
3303 Issuing autochanger "load
1 0" command.
3993 Bad autochanger command: /usr/libexec/bacula/mtx-changer
/dev/changer load
1 /dev/nst0 0
3993 result="Drive 0 Full (Storage
Element 24 loaded)
": ERR=Child exited with code 1
You must correct this error or the Autochanger
will not work.
I suspect my permissions are incorrect,
can someone verify this for me please.
[root@lobacula sbin]# ll -al /dev/nst0
crw-rw---- 1 root disk 9, 128 Jun 16
11:12 /dev/nst0
-----------------------------------------------------------------
Roger Sinel
------------------------------------------------------------------------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It's the best place to buy or sell services for
just about anything Open Source.
http://sourceforge.net/services/buy/index.php _______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- [Bacula-users] btape Autochanger unload error's,
roger . sinel <=
|
|
|