Re: Tandberg Storageloader LT0-4 SAS drive
2009-05-11 14:46:22
On Mon, May 11, 2009 at 1:30 PM, Doyle Collings <dcollings AT loganutah DOT
org> wrote:
> Has anyone successfully created a tape type definition for a Tandberg
> Storage Loader LT0-4 HH with an IBM drive using a SAS interface. Each time
> I try it I get an error message that it cannot rewind the tape. This is
> done using /dev/nst0. I can manipulate the storageloader using mtx commands
> and have been able to write to the drive without any problems.
Is this on Linux? What is the exact error message?
> Dustin, do you know if the SAS interface is supported by Amanda?
Anything that works with the standard 'st' kernel device driver should
work with Amanda.
Dustin
--
Open Source Storage Engineer
http://www.zmanda.com
|
|
|