I have a Tandberg T24 jukebox with an LTO4 scsi connected
to a linux server. I don't recall where I got the tapetype
definition, might have stolen it from my SL24/LTO4 fiber
connected to my Sun x4500... but I don't know where I got
that from... I know I didn't build it. I wonder now if its
not just completely wrong.

On Mon, May 11, 2009 at 02:30:49PM -0400, Dustin J. Mitchell wrote:
> On Mon, May 11, 2009 at 1:30 PM, Doyle Collings <dcollings AT loganutah DOT 
> org> wrote:
> > Has anyone successfully created a tape type definition for a Tandberg
> > Storage Loader LT0-4 HH with an IBM drive using a SAS interface.? Each time
> > I try it I get?an error message that it cannot rewind the tape.? This is
> > done using /dev/nst0.? I can manipulate the storageloader using mtx commands
> > and have been able to write to the drive without any problems.
> 
> Is this on Linux?  What is the exact error message?
> 
> > Dustin, do you know if the SAS interface is supported by Amanda?
> 
> Anything that works with the standard 'st' kernel device driver should
> work with Amanda.
> 
> Dustin
> 
> -- 
> Open Source Storage Engineer
> http://www.zmanda.com
---
   Brian R Cuttler                 brian.cuttler AT wadsworth DOT org
   Computer Systems Support        (v) 518 486-1697
   Wadsworth Center                (f) 518 473-6384
   NYS Department of Health        Help Desk 518 473-0773



IMPORTANT NOTICE: This e-mail and any attachments may contain
confidential or sensitive information which is, or may be, legally
privileged or otherwise protected by law from further disclosure.  It
is intended only for the addressee.  If you received this in error or
from someone who was not authorized to send it to you, please do not
distribute, copy or use it or any attachments.  Please notify the
sender immediately by reply e-mail and delete this from your
system. Thank you for your cooperation.