configure should find mt and mtx binaries if they are in your PATH.
You can override it by setting mtx_binary in the changerfile.
changerfile is defined in your amanda.conf file.

Jean-Louis

McGraw, Robert P. wrote:

The following is from the chg-lib.sh file. What file is the "changerfile"
that is mentioned below.

# These are the defaults discovered by configure when Amanda was installed.
# They can be overridden here, or by by 'mt_binary' and 'mtx_binary',
# respectively, in the changerfile (currently only for chg-zd-mtx.sh and
# chg-manual.sh).

I want to set mt_binary and mtx_binary at compile time but I cannot find
where thisis located.

Thanks

Robert




_____________________________________________________________________
Robert P. McGraw, Jr.
Manager, Computer System                 EMAIL: rmcgraw AT purdue DOT edu
Purdue University                         ROOM: MATH-807
Department of Mathematics                PHONE: (765) 494-6055
150 N. University Street                   FAX: (419) 821-0540

West Lafayette, IN 47907-2067