I'm sure I just
have something written incorrectly, but here's the error I'm
getting
-bash-3.00$
amlabel dailyset dailyset0 slot 0 changer: got exit: 1 str: <error>
could not read result from
"/usr/local/libexec/chg-scsi-solaris.conf" amlabel: could not load slot "0":
could not read result from
"/usr/local/libexec/chg-scsi-solaris.conf" amlabel: could not load slot "0":
could not read result from
"/usr/local/libexec/chg-scsi-solaris.conf" amlabel: pid 1812 finish time Wed
Apr 26 16:27:24 2006 -bash-3.00$
Output of that
file:
-bash-3.00$ cat
"/usr/local/libexec/chg-scsi-solaris.conf" number_configs
1 eject
0 # Tapedrives need an eject
command sleep
15 # Seconds to wait until the tape gets
ready cleanmax
10 # How many times could a cleaning tape get
used changerdev /dev/0bn # # Next comes
the data for drive
0 # config
0 drivenum
0 dev
/dev/rmt/0bn # the device that is used for the tapedrive 0
(BSD type, no rewind, no
compression) startuse
0 # The slots associated with the drive
0 enduse
17 #
statfile
/usr/local/etc/amanda/dailyset/tape0-slot # The file where the actual slot
is stored cleancart
18 # the slot where the cleaningcartridge for
drive 0 is located cleanfile
/usr/local/etc/amanda/dailyset/tape0-clean # The file where the cleanings are
recorded usagecount
/usr/local/etc/amanda/dailyset/totaltime tapestatus
/usr/local/etc/amanda/dailyset/tape0-status #labelfile
/usr/local/etc/amanda/dailyset/labelfile # Use this if you have an barcode
reader -bash-3.00$
Amanada user has
read/write access to /usr/local/libexec and to the chg-scsi-solaris.conf
file.
can anyone point
me in the right direction?
Thanks
|