|
Hi all,
I installed amanda on my server which is a sparc
server.
I configured the server itself as a backup client.
When I run amdump there is no output from planner.
I wonder how I can make it work.
I set up some pause point within planner.c, I can
see the configure info was read in. And also at
some point of planner, amandad daemon was started.
But just there is no output comes out from
planner.
Here are my config:
disklist:
pete c0t0d0s0 comp-root
/etc/inetd.conf:
amanda dgram udp
wait amanda /myapp/am/libexec/amandad
amandad
amandaidx stream tcp nowait amanda
/myapp/am/libexec/amindexd amindexd
amidxtape stream tcp nowait
amanda /myapp/am/libexec/amidxtaped amidxtaped
Thanks
Allen Liu
| 