Hi Jean-Louis;
The patch seemed to do it on my manual run of amreport. I guess there shall
be no differences on the normal daily run.
Thanks a lot to everyone for their help.
----- Original Message -----
From: "Jean-Louis Martineau" <martinea AT IRO.UMontreal DOT CA>
To: "Alfonso Armenta" <alfonsoarmenta AT hotmail DOT com>
Cc: <amanda-users AT amanda DOT org>
Sent: Monday, November 18, 2002 5:20 PM
Subject: Re: printer command defined?
> Hi Alfonso,
>
> Why configure didn't find an lpr (lp) command?
>
> Try this patch.
>
> Jean-Louis
>
> On Mon, Nov 18, 2002 at 10:16:10AM -0000, Alfonso Armenta wrote:
> > Hi everybody;
> >
> > Maybe I am 'unusual' user here, but I got my backups and recover working
100% fine... Just a little detail that I definitely don't like:
> >
> > FAILURE AND STRANGE DUMP SUMMARY:
> >
> > amreport: FINISH no printer command defined
> >
> > I know that data is being dumped properly and that amrecover works
grand... But why can I not show my boss a report without the word failure
written in caps? :)
> >
> > Apologies if this is somewhat obvious or trivial for some of you, but
I've read manpages and FAQs as well as list archives cannot find an answer
to this.
> >
> > Thanks in advance,
> >
> > Alfonso
> >
>
> --
> Jean-Louis Martineau email: martineau AT IRO.UMontreal DOT CA
> Departement IRO, Universite de Montreal
> C.P. 6128, Succ. CENTRE-VILLE Tel: (514) 343-6111 ext. 3529
> Montreal, Canada, H3C 3J7 Fax: (514) 343-5834
>
|