Re: [Networker] EMC Networker / Celerra Data Mover - Can I share a TLU?
2008-12-08 19:17:01
If this is a celerra gateway model, I hope you didn't zone in the tape
drives to be shared with the disk. Not a good idea. You should be using
the aux ports on the datamovers. If not, please disregard.
FYI.
-----Original Message-----
From: EMC NetWorker discussion [mailto:NETWORKER AT LISTSERV.TEMPLE DOT EDU] On
Behalf Of bobalob
Sent: Monday, December 08, 2008 6:12 AM
To: NETWORKER AT LISTSERV.TEMPLE DOT EDU
Subject: [Networker] EMC Networker / Celerra Data Mover - Can I share a
TLU?
davina wrote:
> bobalob wrote:
> Quote:
> davina wrote:
>
>
> Quote:
> Absolutely it is possible. You can do both library sharing and drive
> sharing. This if fully supported.
>
>
> Thanks davina, should I just configure the library as 2 seperate
jukeboxes on networker? one NDMP and one direct attached?
>
> There are lots of ways you can do it. There is no need to configure it
> as separate jukeboxes, you may find it simpler to have all the devices
> in the same jukebox.
Thanks for the information, but i'm getting a little stuck while trying
to configure it. I have zoned both networker and my data mover into the
tape drives and robot. I can add the drive as an NDMP library on
networker which is good, but then cant label tapes or do normal backups
to it. As I only have one jukebox license, I can't then add it as a
local jukebox aswell.
You mentioned I could configure it on networker as a single device? do
you know of any documentation that I could use to view my options? I
have access to powerlink so can grab stuff from there if i need to.
+----------------------------------------------------------------------
|This was sent by d.m.hall AT dorsetcc.gov DOT uk via Backup Central.
|Forward SPAM to abuse AT backupcentral DOT com.
+----------------------------------------------------------------------
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
To sign off this list, send email to listserv AT listserv.temple DOT edu and
type "signoff networker" in the body of the email. Please write to
networker-request AT listserv.temple DOT edu if you have any problems with this
list. You can access the archives at
http://listserv.temple.edu/archives/networker.html or
via RSS at http://listserv.temple.edu/cgi-bin/wa?RSS&L=NETWORKER
|
|
|