Re: Tape Question
2003-06-05 11:17:21
That's been my suspicion of how tapes wind up as private without a
stgpool. So I run this periodically (with a tip of the hat to Paul Seay).
select volume_name from libvolumes where
status='Private' and libvolumes.volume_name
not in (select volume_name from volumes) and
libvolumes.volume_name not in (select
volume_name from volhistory where type in
('BACKUPFULL','BACKUPINCR','DBSNAPSHOT','EXPO-
RT'))
At 10:56 AM 6/5/2003 -0400, you wrote:
Thanks for the q libr command found out that 400 is my private category.
When I look in my act log I find no references to these volumes & they do
not show up in q vol or q libv. Any suggestions about there real status?
Could they be volumes that were mounted in a drive when TSM went down? Also
I tried to check them in they failed on reading the label!
I guess my question is does anybody any reason to NOT recheck them in as
scratch & overwrite the existing label? Did I miss someplace else to check
the status of these tapes with TSM?
Thanks,
--------------------------------------
Bruce Kamp
Midrange Systems Analyst II
Memorial Healthcare System
E: bkamp AT mhs DOT net
P: (954) 987-2020 x4597
F: (954) 985-1404
---------------------------------------
|
|
|