Re: [Bacula-users] Can't make "Truncate on Purge" work.
2015-05-22 15:57:32
On 2015-05-22 at 14:52:30 Bill Arlofski wrote:
>
> Hi Erik
>
> After adding the "Action on Purge = truncate" to your pool(s), you
> need to perform a few extra steps, especially if you have existing
> volumes in those pool(s) already:
>
> In bconsole:
>
> * update pool=PoolYouModified (repeat for each pool)
>
> then to set the Truncate on Purge flag for each volume already
> existing in the pool(s).
>
> * update volume fromallpools
>
> Then, to verify that all of your volumes have been updated:
>
> * llist volumes
>
> Make sure they all have "ActionOnPurge: 1"
>
>
> If this is all good, then the commands Ana explained should now work
> as expected.
>
> Hope this helps!
>
> Have a great weekend!
>
> Bill
>
>
Thanks a lot. I'll check that out in the weekend.
--
Regards
Erik P. Olsen
------------------------------------------------------------------------------
One dashboard for servers and applications across Physical-Virtual-Cloud
Widest out-of-the-box monitoring support with 50+ applications
Performance metrics, stats and reports that give you Actionable Insights
Deep dive visibility with transaction tracing using APM Insight.
http://ad.doubleclick.net/ddm/clk/290420510;117567292;y
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users
|
|
|