Sergio Belkin schrieb:
> The output test was:
> 
> dd if=/dev/zero of=/dev/nst0 bs=1M count=1000
> 1000+0 records in
> 1000+0 records out
> 1048576000 bytes (1.0 GB) copied, 7.80926 seconds, 134 MB/s

This looks ok.
 
> Below is output of tapeinfo -f /dev/sg0
> 
> Product Type: Disk Drive

But sg0 is not the tape drive, it's a disk..

> Vendor ID: 'ServeRA '
> Product ID: 'raid 1          '
> Revision: 'V1.0'
> Attached Changer: No
> SerialNumber: '7E08591F'
> SCSI ID: 0
> SCSI LUN: 0
> Ready: yes
> BufferedMode: yes
> Medium Type: Not Loaded
> Density Code: 0x37
> BlockSize: 3748166
> DataCompEnabled: no
> DataCompCapable: no
> DataDeCompEnabled: no
> CompType: 0x35393146
> DeCompType: 0x300000
> 
> 
> Should I change something?

Show us the tapeinfo output of /dev/nst0 (while it's not in use) and
the complete output (messages) of a bacula job that is too slow.

Ralf

------------------------------------------------------------------------------
Check out the new SourceForge.net Marketplace.
It is the best place to buy or sell services for
just about anything Open Source.
http://p.sf.net/sfu/Xq1LFB
_______________________________________________
Bacula-users mailing list
Bacula-users AT lists.sourceforge DOT net
https://lists.sourceforge.net/lists/listinfo/bacula-users