Yogesh Hasabnis schreef:
Hi All,
I would be grateful if anybody can forward me the
tapetype definition for an HP Ultrium 960 LTO3 tape
device (external). The SCSI controller used is an HP
374654-B21 - 64-bit Single Channel Wide Ultra320 SCSI
Controller. Basically, on what factors does the
tapetype deifintion depend? Else if I need to give the
amtapetype command is the command "amtapetype -t
/dev/nst0" sufficient? Or do I need to specify
additional arguments to the command? How much time
will this command take?
See:
http://wiki.zmanda.com/index.php/Tapetype_definitions#LTO_Ultrium_3_with_400.2F800_Gbyte_tapes
When running amtapetype, please do add a reasonable estimate value:
amtapetype -e 400g /dev/nst0
In that case, it will give an estimate of the total runtime
after a few minutes, usually 4-8 hours.
--
Paul Bijnens, Xplanation Tel +32 16 397.511
Technologielaan 21 bus 2, B-3001 Leuven, BELGIUM Fax +32 16 397.512
http://www.xplanation.com/ email: Paul.Bijnens AT xplanation DOT com
***********************************************************************
* I think I've got the hang of it now: exit, ^D, ^C, ^\, ^Z, ^Q, F6, *
* quit, ZZ, :q, :q!, M-Z, ^X^C, logoff, logout, close, bye, /bye, *
* stop, end, F3, ~., ^]c, +++ ATH, disconnect, halt, abort, hangup, *
* PF4, F20, ^X^X, :D::D, KJOB, F14-f-e, F8-e, kill -1 $$, shutdown, *
* kill -9 1, Alt-F4, Ctrl-Alt-Del, AltGr-NumLock, Stop-A, ... *
* ... "Are you sure?" ... YES ... Phew ... I'm out *
***********************************************************************
|