Javier Sanchez wrote:
I put the no-reuse option on all the tapes using amadmin, but now all
the backups are refused because amanda expects a new tape, did i miss
something to reset ??
'no-reuse' is exaclty what amanda will do with the tapes:
she will refuse to write on them.
Amanda needs (v)tapes to backup. They must all have a different
label. You need at least [tapecycle] number of tapes in the cycle
(note the word "cycle" implies reuse). If you marked some tapes
as no-reuse, then you must add new tapes (with new labels, not
the same as you already have labelled), until you have [tapecycle]
number of reuseable tapes again.
--
Paul Bijnens, Xplanation Tel +32 16 397.511
Technologielaan 21 bus 2, B-3001 Leuven, BELGIUM Fax +32 16 397.512
http://www.xplanation.com/ email: Paul.Bijnens AT xplanation DOT com
***********************************************************************
* I think I've got the hang of it now: exit, ^D, ^C, ^\, ^Z, ^Q, F6, *
* quit, ZZ, :q, :q!, M-Z, ^X^C, logoff, logout, close, bye, /bye, *
* stop, end, F3, ~., ^]c, +++ ATH, disconnect, halt, abort, hangup, *
* PF4, F20, ^X^X, :D::D, KJOB, F14-f-e, F8-e, kill -1 $$, shutdown, *
* kill -9 1, Alt-F4, Ctrl-Alt-Del, AltGr-NumLock, Stop-A, ... *
* ... "Are you sure?" ... YES ... Phew ... I'm out *
***********************************************************************
|