ADSM-L

Re: Tape volume usage - Chris

1998-08-14 13:34:07
Subject: Re: Tape volume usage - Chris
From: Scott Emmons <scotte AT CENTER.USCS DOT COM>
Date: Fri, 14 Aug 1998 10:34:07 -0700
Hmmmm... Are you sure? 99% of my 3590 tapes have >10GB of data on them,
and I have the est/max capacity set at 10GB. Maybe that all depends on
whether or not the drive is allowed to use compression in the device type?

adsm> q dev

Device    Device    Storage    Device    Format     Est/Max     Mount
Class     Access       Pool    Type                 Capacity    Limit
Name      Strategy    Count                             (MB)
-----     ------    -------    -------    ------    --------    ------
[..etc..]
[..etc..]
TLDS_3590 Sequential      6    3590       3590C     10,240.0    DRIVES
[..etc..]

adsm> q vol
A00073             AIXTAPEBACK  TLDS_3590    26,073.2   79.8    Full
A00075             AIXTAPEBACK  TLDS_3590    27,110.3   84.5    Full
A00086             TAPEOFFSITE  TLDS_3590    23,404.3   56.3    Full
A00087             TAPEOFFSITE  TLDS_3590    24,659.2   79.1    Full
A00093             TAPEOFFSITE  TLDS_3590    17,589.5   62.3    Full
A00094             TAPEOFFSITE  TLDS_3590    25,956.3   72.2    Full
A00095             AIXTAPEBACK  TLDS_3590    10,240.0   14.6  Filling
[..etc..]

Thanks,
-Scott
________________________________________________________________________
________________________________________________________________________
    L. Scott Emmons    | CableData R&D Center - El Dorado Hills, CA, USA
Staff Software Engineer|  Unix Administration, Systems Development Dept
    (916) 939-6088     |  Views and content are my own, not CableData's

>-----Original Message-----
>From: ADSM: Dist Stor Manager [mailto:ADSM-L AT VM.MARIST DOT EDU]On Behalf Of
>buser andreas
>Sent: Friday, August 14, 1998 8:10 AM
>To: ADSM-L AT VM.MARIST DOT EDU
>Subject: Re: Tape volume usage - Chris
>
>
>Hi Chris,
>
>If your EST-CAPACITY is only defined to 20GB (see DEV-Config) then ADSM
>will only write this amount of DATA on it even if it could write more.
>
>Tip: Define EST-CAPACITY higher than your physical tape capacity. Take
>care if HW-Compression is in effect, the go even higher.
>
>If you controll the EST-CAPACITY full tapes, and yout have your defined
>EST-Capacity reached, then raise this value again.
>
>Kind regards
>Andreas Buser
>
>Tel:   ++41 61 285 73 21
>Fax    ++41 61 285 70 70
>mail: Andreas.Buser AT Basler DOT ch
>
>Address:
>Basler Versicherungsgesellschaft
>Andreas Buser
>Abt. Informatik
>Aeschengraben 21
>4002 Basel
>Switzerland
>
<Prev in Thread] Current Thread [Next in Thread>