Re: Tape volume usage - Chris
1998-08-14 11:09:43
Hi Chris,
If your EST-CAPACITY is only defined to 20GB (see DEV-Config) then ADSM
will only write this amount of DATA on it even if it could write more.
Tip: Define EST-CAPACITY higher than your physical tape capacity. Take
care if HW-Compression is in effect, the go even higher.
If you controll the EST-CAPACITY full tapes, and yout have your defined
EST-Capacity reached, then raise this value again.
Kind regards
Andreas Buser
Tel: ++41 61 285 73 21
Fax ++41 61 285 70 70
mail: Andreas.Buser AT Basler DOT ch
Address:
Basler Versicherungsgesellschaft
Andreas Buser
Abt. Informatik
Aeschengraben 21
4002 Basel
Switzerland
|
|
|