Re[2]: Tape volume usage - Chris
1998-08-14 10:10:52
Subject: |
Re[2]: Tape volume usage - Chris |
From: |
ALLEN BARTH <abarth AT KEMPER DOT COM> |
Date: |
Fri, 14 Aug 1998 09:10:52 -0500 |
This can't be true, all my devc EST-CAPACITY are at 0, and I'm
certainly writing to tapes, besides the admin guide states that the
parm is optional. Or is zero a 'special case'?
______________________________ Reply Separator _________________________________
Subject: Re: Tape volume usage - Chris
Author: buser andreas <andreas.buser AT BASLER DOT CH> at ~internet
Date: 8/14/98 11:09 AM
Hi Chris,
If your EST-CAPACITY is only defined to 20GB (see DEV-Config) then ADSM
will only write this amount of DATA on it even if it could write more.
Tip: Define EST-CAPACITY higher than your physical tape capacity. Take
care if HW-Compression is in effect, the go even higher.
If you controll the EST-CAPACITY full tapes, and yout have your defined
EST-Capacity reached, then raise this value again.
Kind regards
Andreas Buser
Tel: ++41 61 285 73 21
Fax ++41 61 285 70 70
mail: Andreas.Buser AT Basler DOT ch
Address:
Basler Versicherungsgesellschaft
Andreas Buser
Abt. Informatik
Aeschengraben 21
4002 Basel
Switzerland
|
<Prev in Thread] |
Current Thread |
[Next in Thread>
|
- Re[2]: Tape volume usage - Chris,
ALLEN BARTH <=
|
|
|