That's why I asked if you had a problem.   Most people don't configure this
value unless and until they do have one.   But if you are simply worried
you can do it ahead of time.   And as I said, the Help says the default
value is 800, so we wouldn't query 6000 even in the default  or
un-configured case.

But netmon doesn't query the routing table without a purpose, especially
during discovery.  That's an important part of how automated discovery
proceeds.  So I'd say that zero is a little drastic, wouldn't you?
With zero you may halt automated discovery.  Or you may get unconnected
nodes or networks on the map.

James Shanks
Level 3 Support  for Tivoli NetView for UNIX and Windows
Tivoli Software / IBM Software Group


                                                                           
             "Kain, Becki                                                  
             \(B.\)"                                                       
             <bkain1 AT ford DOT com>                                          
To 
             Sent by:                  <nv-l AT lists.us.ibm DOT com>           
  
             owner-nv-l@lists.                                          cc 
             us.ibm.com                                                    
                                                                   Subject 
                                       RE: [nv-l] Routing table pulled     
             10/14/2005 02:55                                              
             PM                                                            
                                                                           
                                                                           
             Please respond to                                             
                   nv-l                                                    
                                                                           
                                                                           




Do I need it configured at all?  Apparently, this person's concern was
under HPOV, that when it discovered a router, it made 6000 individual
snmp get statements for each routing statement.

What is the impact of setting this to 0?


-----Original Message-----
From: owner-nv-l AT lists.us.ibm DOT com [mailto:owner-nv-l AT lists.us.ibm DOT 
com]
On Behalf Of James Shanks
Sent: Friday, October 14, 2005 2:53 PM
To: nv-l AT lists.us.ibm DOT com
Subject: Re: [nv-l] Routing table pulled


This is configurable in xnmsnmpconf, under the field "Number of Route
Entries".

Default is 800 according to the Help, which you can verify yourself.  If
you think a max of 800 is too high you can set something else.

Are you having a problem or just worried about one?

James Shanks
Level 3 Support  for Tivoli NetView for UNIX and Windows
Tivoli Software / IBM Software Group




             "Kain, Becki

             \(B.\)"

             <bkain1 AT ford DOT com>
To
             Sent by:                  <nv-l AT lists.us.ibm DOT com>

             owner-nv-l@lists.
cc
             us.ibm.com


Subject
                                       [nv-l] Routing table pulled

             10/14/2005 01:41

             PM





             Please respond to

                   nv-l









Folks:


Apparently, under hpov, when a router was discovered, the entire routing
table of the router was pulled as well, causing the cpu to spike because
it pulled one route at a time.  Does NV do the same thing when it
discovers a node?


Thanks