Re: [nv-l] #COM 3300 STACK UNIT REMOVED TRAP
2004-09-24 01:52:49
Jeff,
I don't know anything about this 3COM
switch but if the event is predefined in the RMON-Event-Group, make sure
that the "eventType" is set to either "snmp-trap(3)"
or "log-and-trap(4)".
Also the "eventStatus" must
be "valid(1)".
From /usr/OV/snmp_mibs/rfc1271-RMON
------
....
eventType
OBJECT-TYPE
SYNTAX INTEGER {
none(1),
log(2),
snmp-trap(3), -- send an
SNMP trap
log-and-trap(4)
}
ACCESS read-write
STATUS mandatory
DESCRIPTION
"The type of notification that the probe will
make
about this event. In the case of log, an entry
is
made in the log table for each event. In the
case of
snmp-trap, an SNMP trap is sent to one or more
management stations."
::= { eventEntry 3 }
....
eventStatus
OBJECT-TYPE
--SYNTAX EntryStatus
SYNTAX INTEGER {
valid(1), createRequest(2), underCreation(3), invalid(4)
}
ACCESS read-write
STATUS mandatory
DESCRIPTION
"The status of this event entry.
If this object is not equal to valid(1), all associated
log entries shall be deleted by the agent."
::= { eventEntry 7 }
....
------
Hope this helps.
Oliver
Jeff Fitzwater <jfitz AT princeton DOT edu>
Sent by: owner-nv-l AT lists.us.ibm DOT com
23.09.2004 20:24
|
To
| nv-l AT lists.us.ibm DOT com
|
cc
|
|
Subject
| [nv-l] #COM 3300 STACK UNIT
REMOVED TRAP |
|
Does anybody know how to enable the
TRAPS for 3COM 3300 STACKS so
that when a STACK MEMBER (unit) goes offline it will generate a trap?
I receive traps from the 3300 switch but when a unit of the
stack is
removed or fails I never get a trap.
I do know that 3com uses RMON EVENTS to generate these traps
and
there is one defined in the EVENT group called UNIT REMOVED but I do not
know how to enable it.
Any ideas out there?
Thanks in advance.
Jeff Fitzwater
OIT Network Systems
Princeton University
|
|
|