Sometimes it is just too quick, especially if you use a large
seedfile. Try putting your physical addresses right at the
top of the seedfile. Stop netmon, delete the incorrect nodes,
ovtopofix, and restart netmon.

Cordially,

Leslie A. Clark
IBM Global Services - Systems Mgmt & Networking
Detroit



                                                                                
                                                
                      "CATALINA MARTINEZ"                                       
                                                
                      <[email protected]        To:       <nv-l AT 
lists.tivoli DOT com>                                         
                      tate.tx.us>                     cc:                       
                                                
                                                      Subject:  [nv-l] Physical 
IP vs Virtual IP /Clusters                      
                      04/26/2002 11:21 AM                                       
                                                
                                                                                
                                                
                                                                                
                                                



Hello,

      AiX 4338 Netview 602

      I have a group of clusters (Microsoft Clustering Service) that I need
      to have discovered and monitored using the physical address and not
      virtual. 2 out of the 5 sets of clusters are correct, Netview
      discovered them under the PHYSICAL IP.

      the other 3 sets I have deleted them and netmon continues to discover
      them with the virtual ip (first). I entered the physical ip on the
      seed file, did a netmon -y, deleted the nodes, ovtopofix, and waited.
      Netview discovered them again with the virtual ip..

      How can I get netview to use/discover the physical ip first and not
      virtual?

      Catalina